This is a serial/parallel-USB/LAN conversion driver to make an Epson TM/BA/EU printer connected via USB or LAN accessible from a POS application through a virtual serial or parallel port. It allows you to directly control devices connected via USB or LAN with ESC/POS commands without making changes in the POS application that controls devices connected via a serial or parallel interface. [Note] Due to the addition of the virtual parallel port, the old software 'TMCOMUSB' is replaced to 'TM Virtual Port Driver'. • • • • • • • • •. EPSON Projector USB-Virtual COM Driver by SEIKO EPSON Corporation. Versions: 2.5, 2.4, 2.3, 2.1 and 2.0. File name: EIN_DRV.exe. Official Epson® projector support and customer service is always free. Download software, access FAQs, manuals, warranty, videos, product registration and more. How to install an Epson TM Printer using the virtual Port Driver Download Link for most Epson TMprinters: Download Link for TM-S9000MJ/TM-S2000MJ only: Download and install the Utility. Once the installation is finished, or after you start the utility, you’ll see the following screen: If the System you are using has some actual physical COM-Ports, they’ll be marked as used. Select a free COM-Port and press the “Assign Port” Button. Attention: The selected Port later needs to be assigned in the back-end instead of the usual system printer. You should see the following screen: Just select the line “The first recognized device is automatically assigned to this port.” with “TM printer port” selected underneath. Alternatively, if you are using more than one USB-Printer on your machine or your printer is shown above you can select the specific printer. If you are using an TM-T88V or TM-T20, you may have to go to the last tab “Command Emulation” and check “Enabled ESC/POS CommandEmulation” as shown below. No other tab needs to be adjusted, so just click OK. The utility will set up your COM-Port and you’ll land in the starting screen with the assigned port adjusted. After you connect your printer to the POS, you should use the “TestPrint” feature to make sure everything works well. The program can then be closed. Keep in mind that if your printer is set up this way you’ll have to choose the appropriate Port in the POS Profile.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
November 2018
Categories |